Welcome to CarandTruckRemotes.com video channel.
Today we’re going to show you how to program a remote for… we are in the Cadillac Escalade,
but those instructions also work for most full size GM trucks and SUVs, and also some
cars like Chevy Impala ’05 and up or Buick Lucerne. So, alright, it’s actually very
easy. We have one remote that’s programmed, and
a couple of remotes that do not work right now.
All you have to do is to switch ignition to ON position, then you have to press repeatedly
the button right here. On certain vehicles maybe, it may be placed in a different area.
You have to keep pressing it until you see “relearn remote key”. OK, so we got that.
Now we have to push this button right here (the check mark button). OK, “remote key
learning activated”. OK, now we have to press LOCK and UNLOCK buttons on the remote,
and just keep holding them down for about 15 seconds. (*beep *beep). Apparently that
was enough, it didn’t need 15 seconds. OK, now we have to do the same thing with
the existing remote to sort of synchronize (*beep *beep).
OK, now both remotes should be working. So, we switch the ignition OFF to exit programming
mode. And let’s see if it works. OK, and now this
remote. Now both remotes are programmed. As you see
it’s very easy. Again, the same procedure works for most:
GM Trucks and SUVs and some GM cars. All you have to do is just utilize the information
center. Which is located either here, somewhere here, or on the other side for some cars,
and the display tells you what to do as well. So, again, very easy procedure, you can do
it by yourself. Those remotes are available on our website at CarandTruckRemotes.com
Thank you very much. Bye.